i found out that the injector that BMP sells you when you get their Dbilas itb kit are 24lb'ers. my question is will the stock "i" motor support these monsters? i can't remember but i think that it was 2.5 or 3.0 on the stock FPR. i am trying to avoid getting an adj frp if i can. this may seem like a dump question to some, buy forgive me i am still somewhat ignorant on pulsed injection as i am used to CIS injection that uses GIANT pressures to get the same thing done. i am finally trying to get the FI totally dialed in on the car (it's only been 2 years :roll: ), and after fixing all kinds of wiring issues from the P/O's instal of the ITB's and piggy back i'd like to know if this is going to present another problem.
thanks,
greg
thanks,
greg
Comment