can someone with a steady hand do this easily? also is there an angle to it or is it straight in? its REALLY close to the bolt hole and you have one shot to get it right so i was just wondering. i was thinking about practicing on a junk head.
-
-
Take it to a machine shop, won't end up being very much. They can also check the head for cracks alot easier and resurface etc if needed.:: PNW Crew ::
'87 325 4dr, '74 2002 -
:stupid: IMO it is the safest thing to do.sigpicComment
-
thanks guys, i took it in a couple days ago and he only charged 30 bucks, what a steal, he said it would only take him a few mins to get the angle off the other holes and put it on an bench where you can set the angle and drill down.
Thanks for the advice :) i was going to do it myself but chickened outComment
Comment