HELP!! - My ride is FROZEN!!

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Devil Inc
    E30 Modder
    • Jan 2008
    • 802

    #1

    HELP!! - My ride is FROZEN!!

    Well I went out this morning to start my car, since it hasn't been driven to incliment weather here in NE Indiana. When I cranked it over it chugged and chugged, it wasn't a normal chug. So I stopped, popped the hood and my coolant hoses are slushy and even frozen in some spots. I checked the weather for this next week and it is getting warmer, but not much to consider thawing out a possibility. I don't have a garage, but my neighbor has a medium sized pole barn that I could possible use to get it out of the weather. Are there any precautions as to how to thaw it out?And what would be the best way to thaw it out? Also, I will be doing the "I" swap with new gaskets and such, so I will be pulling the head.

    Hopefully that will make it easier.
  • mitch500
    E30 Enthusiast
    • Jan 2006
    • 1092

    #2
    dont suppose you have a block heater do you.? if so plug it in.
    1988 e30 alpine white vert 5speed
    1987 e30 325 eta
    1983 e28 533
    2001 x5 4.4l
    1997 e36 M3 Alpine white 5speed
    1991 Jeep XJ I6 4.0

    Comment

    • DaveSmed
      E30 Fanatic
      • Apr 2007
      • 1406

      #3
      Gee, something tells me you aren't running the proper mixture of antifreeze/water.
      -Dave
      2003 Lincoln Towncar | 1992 BMW 325iC | 1968 Cadillac Deville

      Need some help figuring out the ETM?

      Comment

      • BBY1104

        #4
        Isnt there a certain kind of coolant that is both good for the car and is never suppose to freeze. Comes already mixed, but it sounds like there is to much water in the and not enough Anti-freeze

        Comment

        • swimstarguy
          Advanced Member
          • Nov 2006
          • 131

          #5
          I'd look into that. Make sure you have the right mix and the right antifreeze.

          A buddy of mine had a Chrysler Cirrus (or whatever it was) and the coolant froze. Apparently, the coolant was only good for 5*. Currently, it's -8 by my house, before windchill.


          ~Zar4

          Comment

          • DaveSmed
            E30 Fanatic
            • Apr 2007
            • 1406

            #6
            Are you guys kidding? I hope so.

            Plain old green ethylene glycol antifreeze has a freezing point of -30 degrees when mixed properly. If you are that cheap to water it down.... Can't even say the %50 ratio is too hard to figure out anymore, they mix the stuff for you these days!!!!!
            -Dave
            2003 Lincoln Towncar | 1992 BMW 325iC | 1968 Cadillac Deville

            Need some help figuring out the ETM?

            Comment

            • JAM
              E30 Addict
              • Feb 2007
              • 524

              #7
              Originally posted by DaveSmed
              Gee, something tells me you aren't running the proper mixture of antifreeze/water.
              wrd. not good
              Originally posted by Mr Watsonsilver
              driving boards?

              Comment

              • jlevie
                R3V OG
                • Nov 2006
                • 13530

                #8
                Your best course of action at this point would be to get the engine started and let it run for a few minutes. Then shut it off and wait 10-15 minutes before repeating the short run. Repeat that process until the temp gauge is out of the blue. Watch the engine for any sign of leaking coolant and stop if you see a leak. Those short runs will discharge the battery, so connect a high capacity charger or use a second vehicle as a donor.

                Assuming that you do get the engine warmed up without exciting things happening, the next step is to drain the coolant and replace with a 50:50 mix of anti-freeze and water. Note that this means opening the block drain and having the heater set to full hot.
                The car makes it possible, but the driver makes it happen.
                Jim Levie, Huntsville, AL

                Comment

                • Devil Inc
                  E30 Modder
                  • Jan 2008
                  • 802

                  #9
                  Yes, I guessed that the coolant ratio isn't correct because I've been losing coolant at startup when the engine is cold. I didn't think I had added that much water to the mix. I think the head is cracked or warped, bought it with a blown head gasket. Replaced head gasket cause it was pumping coolant into the two middle cylinders. I did a visual check of the head when I did this, didn't see anything out of the ordinary. So I have a new, used head, new gaskets and such. If I can get it to my neighbors storage barn, I have access to a salamander heater. Would I be safe to start tearing the head off with it still "frosty"?

                  Comment

                  • evil_twin
                    R3VLimited
                    • Nov 2007
                    • 2965

                    #10
                    Damn that sucks. That shit happened to my e34. The reason I had water in it was to flush the system out of all the crap thats been sitting in it since 1999. The weather dropped down cold fast, and I ended up paying more... new heater core and radiator.

                    in the end don't try to save a couple of bucks, and if you are going to clean the system, do it in a few days, not weeks. lol.
                    I got a fender roller now! LMK if you need me to roll your fenders or want to rent the tool from me locally.

                    Paypal: vdang5@gmail.com

                    Delta Auto Care
                    2875-C Towerview Road
                    Herndon, VA
                    703.435.1375

                    My Feedback Thread: Evil_Twin

                    Comment

                    • e30jones
                      Member
                      • Mar 2004
                      • 42

                      #11
                      Originally posted by jlevie
                      Your best course of action at this point would be to get the engine started and let it run for a few minutes. ...
                      I would disagree with this, if his coolant is frozen in the rad hoses, there is a good chance that it is frozen around the water pump as well, and could possibly do damage if started. I purchased an 85 318i last winter, apparently the previous owner didn't mix his coolant properly, so in the first week of ownership, I ended up replacing the rad, and putting new o-rings on the heater valve (in the middle of winter in my driveway). I consider myself lucky, as it is possible to crack the block/head when coolant(water) freezes, expands and has nowhere to go.

                      I ended up thawing my engine completely in about 2 hours, by purchasing two of those crappy mini-heaters from a hardware store and setting them in the engine bay with the hood closed almost all the way. The outside temp was around -10 celcius, and I had defrosted the iced coolant fairly quickly. After it's thawed a bit, I would get that old coolant out of there, drain the rad and block and replace it with properly mixed new stuff.

                      Comment

                      • scabzzzz
                        Estado de mierda de encargo
                        • Jul 2007
                        • 6870

                        #12
                        This kind of happened to me once on my swapped E36 a while ago. Water pump was frozen up and I drove it for a while. Never got any heat and it started to over heat. Opened my radiator catch tank and there was ice floating around in there. I had leaking issues the previous summer so I was putting water in instead of properly mixed anti freeze..

                        I basically followed the methods that Jlevie just described. It works E30jones.

                        Comment

                        • e30serg
                          E30 Addict
                          • Dec 2006
                          • 562

                          #13
                          If the water's frozen inside the engine, the freeze plugs on the block will pop off-that's what they are there for. Check around both side and rear of your block just in case. The last thing you want to do is start that engine up and have all the coolant come out through the freeze plug holes.
                          Can you get a heat gun and melt the ice?
                          Move to a warm state....

                          Comment

                          • Devil Inc
                            E30 Modder
                            • Jan 2008
                            • 802

                            #14
                            e30serg, I agree with you on the move to a warmer state. As for the freeze plugs they appear to be normal. I'll be diving into all of this, this weekend. I don't feel comfortable trying to start the engine with it in this condition, so I think that I might try the heaters under the hood.

                            Comment

                            • Burning2nd
                              Member
                              • Feb 2008
                              • 98

                              #15
                              why wouldnt you... thats what they are there for... start the engine warm it up... it will become unfrozen fast.... at that point you will know very fast if you blew the plug.... if you did.... G/l if not drain and refill... my beem'rswanson love the cold... we saw a bunch of negtive number this year.... the powersteering does'nt like it but fuck him (the p/s) he can wine all he wants..
                              04 e83 X3
                              01 e39 540M
                              97 e36 328is


                              Specializing In BMW, Audi, Mercedes Benz, Porsche ,Volkswagen




                              sigpic

                              Comment

                              Working...