Guys who have used the m20 harness - question

[e30_kid89]

So I'm taking the time to clean up my m20/MS/M30 harness. I wanted to use the B35 injector box instead of my exposed wire cut up m20 box remains i'm currently using. I'm looking at the injector plug but i'm still stumped on how to remove the plug without too much damage and reinstalling into the b35 box..Any one do it? If so how?

Thx!

[PeaveyBassist]

The round plug for the injector harness on an m20? Unscrew the bottom (engine side) of the harness. Then there is a plastic ring that holds the injector harness to the bracket. Unscrew that and the injector harness comes out. Injector plugs come off by a different way. There is a metal clip that goes around the injector. Take a small flathead screwdriver and snap the metal clip off the plug and the plug comes off the injector. That make any sense?

[yert315]

your question is very confusing.
Are you wanting to use the injector harness cover from the m30 harness with your m20 injector wires?

[LowR3V'in]

Seems that way.
I couldn't figure it out either, unless I cut slots in the b35 cover.

or cut/splice.

[zaust]

Just use a m30 harness, It is easy and look's much neater.