Anyone make a Drop in Wire harness for B35?

[xxx-Lost-Soul-xxx]

I am looking to see if anyone here makes a B35 335I Wire harness?
Id rather just pay someone to build the harness then if i do it.

The shell is a 9/84 325e with a 88 E32 motor. Thanks

[Jean]

Sure, you have a harness or would you need to buy one ? Mine is made w/o any kind of adapters, there are multiple ways to do this.

[xxx-Lost-Soul-xxx]

jean pm sent

[MR 325]

Use the E30 i harness. :)

[CorvallisBMW]

Use the E30 i harness. :)

This. Everything plugs right in, all you have to do is lengthen a few wires that don't reach like the TPS and ICV. I didn't even remove my harness from the engine bay, it's THAT easy.

[browntown]

the op has an eta though, don't think the i harness just "plugs in" to the e's.

[CorvallisBMW]

the op has an eta though, don't think the i harness just "plugs in" to the e's.

Use the E30 i harness. :)

[alpinacsi]

Going thru the same thing. The chassis side c101 connector is rectangular but the engine harness has the round c101 connector. I plan to convert the chassis side to the round type.

[wildstoats]

Going thru the same thing. The chassis side c101 connector is rectangular but the engine harness has the round c101 connector. I plan to convert the chassis side to the round type.

I actually had the opposite on my swap. Went from square engine side (B34) to round c101. My only advice is learn to read and understand the wiring diagrams.

[xxx-Lost-Soul-xxx]

So no one here makes one to sell? I can do my own But i dont want to.

[1987E30project]

Get an 87 325i harness. That is the easiest one to use. You get the round C101 connector and you don't have to deal with the later injector harness issues. There is no way around it you have to extend some wires but it is not that difficult. Good luck.

[xxx-Lost-Soul-xxx]

What About a 91 325iA harness Can i use that?