[CA] looking for a cheap manual flywheel for an M30

[kronus]

Hey guys, looking for a cheap M30 flywheel for a swap project. As cheap as possible is preferable, this is Lemons and we can't afford the good stuff.

[CorvallisBMW]

Find a junk yard 533i or 733i, they are factory lightened :)

[KenC]

M30 in your LeMons car? Bring lube for BS ;)

[slammin.e28]

Find a junk yard 533i or 733i, they are factory lightened :)

...but only the early ones.

M5 too. 15lbs rather than 22lbs. Usually run $100 to $150.

I just sold one for $100.

[kronus]

M30 in your LeMons car? Bring lube for BS ;)

Nah, we're doing this legit. We got a monster residual because our motor done blowed up. Full docs on everything :D

[KenC]

Nah, we're doing this legit. We got a monster residual because our motor done blowed up. Full docs on everything :D

Ahhh. I guess if you have a legit residual, you'll get by with it.

b34 or b35?

[kronus]

Ahhh. I guess if you have a legit residual, you'll get by with it.

b34 or b35?

b35 from a fine affluent gentleman who's putting an S38 in his 635 and just wants it out of the shop.

[CorvallisBMW]

Oh HELL ya!

[kronus]

Oh HELL ya!

I know :D It'll be ridiculous with the lack of weight in the back. Probably going to end up pouring cement in the spare tire well to balance it out.

[CorvallisBMW]

I would highly recommend it. Get a large front swaybar, disconnect the rear. Oh and don't weld your diff ;)

[kronus]

we're probably sticking with the 2.93S to keep accidental drifting to a minimum - I heard corner workers don't like that...

unfortunately, we definitely don't have the budget for a bigger front sway.

[bmw335isturbo]

we're probably sticking with the 2.93S to keep accidental drifting to a minimum - I heard corner workers don't like that...

unfortunately, we definitely don't have the budget for a bigger front sway.

The 2:93s is not bad its just little tall.
what spring-shock combo are you useing?