If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I just got my motor in and wiring harness hooked up in my e24, went to bump the motor over and it will not crank. I have 12v to the starter, grounds appear to be good, and main relay appears to be good also. Any ideas?
I had it on the wrong plug! There is actually one underneath the starter that it is supposed to go on. Thought I should update this with the resolution. Fired right up after that.
Comment