M30b34 turns over but no spark.

[ThatOneEuroE30]

Trying to get my car to fire up but I'm having bad luck. The motor will turn over but no spark. I've replaced the cap and rotor as well as plug wires. It's wire up right. Could the ignition cool be a problem for no spark? Is there a correct way to check for spark I'm just pullin a plug wire and turning it over and looking for a spark. Please help


Edit not getting any fuel as well

[scoobydo]

what ecu, without the ecu knowing the position of the crank there will be no fuel delivery or spark, depending on ecu.

Obviously when checking for spark the ground tip of the plug needs to be near or touching ground, top nut of suspension turret is a good place.

[ThatOneEuroE30]

Running a 179 ecu

[Red88]

Have you tire swapping the cps and spark plug inductive pickup plugs?

[ThatOneEuroE30]

Like where there plug in on the harness? No.

[ThatOneEuroE30]

Put a multimeter to my ecu plug and relay plugs and they are getting 0 power whats is wrong !?!?!?!

[Jb325is]

Search OBC relay issues. I had this issue with my car and I ended up having to jumper the green plug under the dash. It was a long time ago though so I don't remember exactly what the issue was

[kronus]

EDIT: all that was wrong

[ThatOneEuroE30]

Is there a DIY. I'm sorry but wiring is not my forte reading wiring diagrams for me is like telling a blind man to read. And wiring in General is confusing.

[ThatOneEuroE30]

K so I'm getting power and fuel now and spark at the coil but not in the plugs.

[ThatOneEuroE30]

Getting fuel and spark in plugs now but no fire. even gave it a hit of ether and it still didn't fire

[scoobydo]

got to be either timing, firing order or no compression.

[Red88]

If you adjusted the valves since the last time the engine ran I would double check them.

[ThatOneEuroE30]

Haven't touched them all I've don't is a b35 intake swap as well as 1.3 is there a certain way to bolt the harmonic balancer on if so then that could be it cause the b34 balancer is smooth as the b35 has groves

[hotdish]

The b35 harmonic balancer/tooth wheel only bolts on one way IIRC. It should have a small hole in it that lines up with a peg on the b35 crank.

I'm not sure if the b34 crank has this alignment peg for the balancer, is it possible that yours is on wrong, throwing the timing way off?