So as some of you might know I busted the oil pan on my 86 325es (but upon pulling the pan i found bits of metal in my pan, later found to be whats left of #1....) so i finally decided to go through with the swap (89 I motor into my 86) so i have the motor, and alot of other goodies that are gona get replaced while the motor is out and was just wondering if I missed anything.
So new goodies are,
New motor mounts,
New clutch kit from bma,
New tranny mounts,
New guibo (flex disk),
New Center support bracket and bearing,
New exhaust flange gaskets,
New front and rear brembo blanks,
New ATE pads front and rear,
Umm newish hoses(thanks to ericsE30),
Pelican parts shifter rebuild kit.
Did i miss anything?
So new goodies are,
New motor mounts,
New clutch kit from bma,
New tranny mounts,
New guibo (flex disk),
New Center support bracket and bearing,
New exhaust flange gaskets,
New front and rear brembo blanks,
New ATE pads front and rear,
Umm newish hoses(thanks to ericsE30),
Pelican parts shifter rebuild kit.
Did i miss anything?