I made a table that the motor sits nicely on but I have one problem, the oil pan sits on one side and the other side is supported by the vibration dampener.
I only have it resting on the table (its a square w/ a hollow middle) when I work on the motor and then prop it back up in the air when I'm done.
So, my question is (hopefully not a dumb one), if the motor is resting on the rear oil pan and the vibration dampener, should I be concerned about the weight bending the vibration dampener or what it is connected too?
I only have it resting on the table (its a square w/ a hollow middle) when I work on the motor and then prop it back up in the air when I'm done.
So, my question is (hopefully not a dumb one), if the motor is resting on the rear oil pan and the vibration dampener, should I be concerned about the weight bending the vibration dampener or what it is connected too?
Comment