91' m30 into 84' 318i, engine wiring.

[flawdaboi407]

Im using the e34/e32 auto harness and was doing some research on e30.de. I found the wires I think I need....

e34/e32 harness:

#1 - BL: alternator
#4 - BR/VI: coolant sensor (use e30's)
#5 - BR/GN: oil pressure switch/sensor
#7 - GN: ignition coil
#9 - SW: rpm signal/output??? need this?
#13 - GN/VI: 12v to fuel pump relay
#18 - SW/GE: starter

Any thoughts??? Im missing one wire.... which one is it? Do I have it right? Also I was looking at my cars harness and its colors and tried tracing them down! I have a 84' 318i l-jetronic 8pin connector.


my harness chassis side:

#1 - BL : Alternator
#4 - BR/VI : Coolant temp sensor
#6 - GN/GE :
#7 - R/VI : Fuel pump
#8 - SW/GE with another small SW/GE : Starter
#10 - GN : Coil
#16 - SW/BR : Oil pressure switch
#17 - WS/BL :




German: http://wp1016621.wp027.webpack.hoste...105/f00105.htm

English: http://translate.google.com/translat...F8&sl=de&tl=en

[flawdaboi407]

any ideas...? thanks.


p.s my thread on e30tech http://www.e30tech.com/forum/showthread.php?t=64184

[kylebes1]

m30/e30
1/1
4/4
13/7
18/8 tie small wire into the same connection
7/10
5/16
9-> Black wire in glove box above DME

I'll double check, but that should be it...

[peerless]

#17, WS/BL goes from the diagnostic connector to the SI lights in the dash.

This is to reset the light.

[flawdaboi407]

thanks. I finally can start! I just need a clutch and radiator!!