almost there

[xlr8rbob]

ok, so the POS is finally in. (started about a week ago)

tried to crank it this evening and only turned over. im not getting spark or fuel. i know i missing someting
as far as wiring. ive scoured all 25 pages trying to debug this thing tonight and hopefully i can get it worked out tomorrow.

the car is lookin good. once its running i clean her up and then destroy some tires.

thanks to all you guys at r3v for all the inspiration and info.

heres a taste.

90 e34 m30
e34 5spd
funk mounts
jimc chip
ie radiator
ie poly motor/tranny mounts
e28/e30 driveshaft
3.73lsd

ie st3 springs
koni adjustables
gc rsm
ie sways
akg bushings (entire rear subframe)

ss lines
ate slotted rotors
hawk hps pads

[euroshark]

Nice. Which wiring harness did you use?

[speedhop]

That's a damn good looking car. What wheels?

[xlr8rbob]

used the e34 harness. didnt start because for some reason i disconnected the white and yellow relays by the ecu. plugged them in today and she started right up.

idles a little rough but i was able to do a few doughnuts in the adjacent parking lot.

will post a vid in a bit.

the wheels are 16x9 et15 borbet type As with flat caps.

thanks again r3v.

[xlr8rbob]

double threads FTL.

r3v link with video

[AlpineBlanco80]

what fly wheel clutch combo u using? im trying t decide. sweet car.

[aintnothang]

amazing car brother.

[xlr8rbob]

^^^^^
appreciated

the stock set up went in. but im gonna have to replace them really soon.
the pressure plate is not holding up in the higher rpms.

im thinking a fresh stock set-up will hold just fine. i mean they can hold 250hp easily and its pushing almost 1000lbs less of car.

im might look into shaving the flywheel but only a bit since i think a bit more mass will be beneficial to DD and drifting.

tcd has some nice hardware but its a bit out of my price range at the moment.