i have a 2.7i conversion.
eta block with eta 260 (full dme swap)
i have searched like crazy, with no answer!
what things do i need to run "i" clutch/flywheel set up?
assuming:
1) i clutch (springs on the clutch)
2) i flywheel (single mass)
what about:
1)TB
2)fork
3)starter
eta block with eta 260 (full dme swap)
i have searched like crazy, with no answer!
what things do i need to run "i" clutch/flywheel set up?
assuming:
1) i clutch (springs on the clutch)
2) i flywheel (single mass)
what about:
1)TB
2)fork
3)starter