clutch master broke..literally

[yert315]

I go to push my clutch in and it "clicked" then hit the floor.

This happened after about 5k miles of driving on the new cylinder. I'm thinking JB Weld until I can get a new one? Any other ideas?

[NC325iC]

hard to see what happened in those pics, explain

[yert315]

it broke at the red line

[lucky7]

i may have an old OEM one i could sell to you for CHEAP. PM me!

[yert315]

I just bought a new one online. Too bad monday is a holiday. I don't think I'll get it until late next week.

Regardless, PM sent

[yert315]

Found the cause of the problem. I'm missing #27 (bush bearing) in the diagram. Had the bolt too tight and restricted movement. Went to press the clutch in -> the master cyl attachment didn't swivel -> snapped off. Ordered all new parts, should be in this week.