flywheel torque specs??

[will61]

im currently doing a 5 speed swap and im ready to put the 260 in but i need to know how this stuff should be torqued. Anything else that needs to be torqued to spec?

any input would be greatly appreciated

::::::::::::edit:::::::::::::

i also need pressure plate specs

[Aptyp]

run to autozone/advance auto and get a Hayne's manual for torque specs


and put blue Loctite on everything...

[idanity]

install with loctite 270
105 +-7Nm (77 +-5 ftlb)

and star pattern should work
but in the bentley, it shows

1 oclock
7 oclock
3 oclock
9 oclock
5 oclock
11 oclok
6 oclock
and 12 oclock for the last bolt

as i know.
its better to evenly tighten anything.
so snug them up in star pattern or above pattern
and then
torque them up to above pattern.


if you torque the 1st bolt up and then do the rest, by the time you get to the last bolt the 1st bolt will not be in spec.,

bolts on by hand and evenly tightened will always be best.

[will61]

thanks guys, those torque specs will work

[will61]

could i also have the pressure plate specs?