5 speed swap: interesting discoveries, cruise control and others

[nmlss2006]

This was over two years ago: unfortunately I do not have pictures, but it's not overly complicated.
Edited to add, pictures are in page 1 here:

http://www.r3vlimited.com/board/showthread.php?t=120917

[AlphaE]

Swap comin soon. I got alldata access but pics would be better. Thanks!!

[HarukoE30]

This thread needs pictures, bookmarking for further study.

For reals, without pictures I might as well be doing the job in the dark.

[browntown]

This thread needs pictures, bookmarking for further study.

[CabbE30]

it's still ghetto. the part of the auto harness you need to eliminate is pretty small, and then you don't have a silly switch to mess with.

Yes i know. After a week Im already over flipping that motherfucker. I'll just pull the harness this weekend & grab a clutch switch from pnp.

[nando]

it's still ghetto. the part of the auto harness you need to eliminate is pretty small, and then you don't have a silly switch to mess with.

[CabbE30]

Added a toggle switch in my car for the green wires. Took like 3 minutes and CC works.

[nmlss2006]

Clutch switch 61318360421
Clutch switch bracket 35111157815
For all cars 9/87 and up (MY88+)

[AnnaB]

clutch switch bracket & switch - airbag car

noting this thread is a little old - i noted mention of the clutch bracket / switch within the airbag cars. My pedal set (my conversion) didn't have the clutch bracket or switch, so I'm looking for these parts. The realoem.com parts diagram lists these parts as nbrs 32 (bracket) and 34 (switch) - but the table associating the part numbers to the diagram only goes up to part nbr. 30. Pelican wasn't able to find the parts either. Anyone have the part nbrs for the bracket/switch on a airbag car?

[nmlss2006]

Definitely. Lucky though: I have everything out of the car save for the dash and I still had a bad time getting the bracket to clip.

[nando]

mine already had the bracket for the clutch switch. wierd huh?

[nmlss2006]

And by the by, I finished this too. The bracket that holds the switch is a positive DELIGHT (...) to get in.

[nando]

I never did the clutch switch on mine. It works fine, just don't press in the clutch if you're using CC. :)

[gasgasrider]

Done. It just took a while to find where the harness that plugs into the switch was hiding. Found it, on my '88, to the right of the steering column with a short different color jumper at a 90 degree angle. Left the jumper and it's 90 bracket in place, relocated the harness to the switch and I have one less thing on my list. Thanks for the motivation!

[nmlss2006]

Do install the clutch disconnect switch. The parts are $15 new and it's a 20 minute job.