Driveshaft Alignment

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • saxguy09
    Advanced Member
    • Jun 2010
    • 187

    #1

    Driveshaft Alignment

    Putting in a new driveshaft here soon. Old one kept killing CSBs very fast. The ujoints were great but after removing the shaft for the 3rd time this summer, found a dead spot in the rear u joint. So that I don't cause myself another problem, are there any other alignment issues I should check out while I'm under there?
    sigpic
  • jlevie
    R3V OG
    • Nov 2006
    • 13530

    #2
    Check the motor and transmission mounts. If they are bad it can cause misalignment of the drive shaft. Other than that there are no other alignment issues, but don't forget to pre-load the CSB.
    The car makes it possible, but the driver makes it happen.
    Jim Levie, Huntsville, AL

    Comment

    • saxguy09
      Advanced Member
      • Jun 2010
      • 187

      #3
      just checked em, theyre good, thanks!
      sigpic

      Comment

      Working...