im finishing my m50 swap but thought I just post in this section,
My clutch pedal stays to the floor. I try to bench bleed but all I get
is air and if any little sprays of fluid (I think its just the fluid in the lines before)
Does this sound like a fail master cylinder? The slave cylinder doesnt seem to be leaking so thought I would rule that out.
My clutch pedal stays to the floor. I try to bench bleed but all I get
is air and if any little sprays of fluid (I think its just the fluid in the lines before)
Does this sound like a fail master cylinder? The slave cylinder doesnt seem to be leaking so thought I would rule that out.
Comment