FU(&!^NG output flange nut

[bloodshot-e30]

what size is it?

30 or 32 mm?

[jim325]

I believe it is 30MM. I just took mine off and had to buy a socket to fit it. Socket's at work tho so can't 110% confirm but that's my story and im sticking to it.

[LJ851]

30mm. Remove the locking ring around the nut first. Needs to be a relatively thin wall socket.

[LowR3V'in]

Get a screwdriver or pliers and just mangle that washer out.
You won't be able to get the nut off, or even fit a socket unless it's out.

If you don't want to spend like $35 on a nice protos get cheap china 30mm,
put it on a drill, and spin it on bench grinder till it's thin enough.

Hope that help and good luck.

[bzboardz]

Get a screwdriver or pliers and just mangle that washer out.
You won't be able to get the nut off, or even fit a socket unless it's out.

If you don't want to spend like $35 on a nice protos get cheap china 30mm,
put it on a drill, and spin it on bench grinder till it's thin enough.

Hope that help and good luck.

good info

[bloodshot-e30]

i have one ground down for when i changed it in my last trans but this is an eta one i need to take off so i have a good 3 inches to squeez through lol