what can I replace on my trans/shifter assembly w/o removing

[bastianshaw]

trying to weight whether or not its worth the work to drop the whole tranny> If I did, I might as well replace the clutch and get the flywheel lightened.

I REALLY want to replace the carrier bushing in the shift linkage the one where the selector rod meet the transmission

I also need to replace my output seal can this be done w tranny intact?

[FLG]

You can rebuild the linkage and replace both the main seal and shift linkage seal with the tranny in place. Just need to remove the drive shaft.

Sent from my Galaxy Nexus using Tapatalk

[Wanganstyle]

trying to weight whether or not its worth the work to drop the whole tranny> If I did, I might as well replace the clutch and get the flywheel lightened.

I REALLY want to replace the carrier bushing in the shift linkage the one where the selector rod meet the transmission

I also need to replace my output seal can this be done w tranny intact?

if you want to replace the knuckle and its foam where the selector rod meets the transmission you need to:

remove trans mount
remove guibo
remove shift linkage unit
then you can get to the selector rod joint.

[bastianshaw]

so output shaft seal
rebuild shift linkage anything else?

[FLG]

shift linkage seal as well

Sent from my Galaxy Nexus using Tapatalk

[bastianshaw]

Guys I cant find any seals or part numbers on real oem are trans seals listed under somthing else?

[FLG]

What year/model?

Or...call up blunttech and tell em what you need.

[bastianshaw]

an 89 is

[bastianshaw]

bump for pns

[Wanganstyle]

bump for pns

pm blunt and order them all

[ROLLingKING]

Yea im doing mine asap and going to blunttech so I dont get some BS wrong gaskets.

Also idk if your reverse light sensor works when it feels like but I just swapped that out yesterday with the Trans in.
I also did my shift kit with the tranny in. hardest part is getting to the bitch clip and getting the new bushing to fit.
Maybe its because I have an early model but my bushing didnt fit. I think uuc has a bushing for there. get that one