Resurfaced flywheel, do I need a shim?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • cheek
    Noobie
    • May 2012
    • 7

    #1

    Resurfaced flywheel, do I need a shim?

    ,
    Last edited by cheek; 09-17-2017, 03:16 PM.
  • jlevie
    R3V OG
    • Nov 2006
    • 13530

    #2
    The hydraulic clutch is self adjusting, so the engagement/disengagement point will be about the same even if you take a good bit off the flywheel. Only if the flywheel was reduced in thickness so much as to run out of slave cylinder travel would there be a problem.
    The car makes it possible, but the driver makes it happen.
    Jim Levie, Huntsville, AL

    Comment

    Working...