squeaking like rubber on rubber coming from tranny area

[richardkeith97]

so i thought my blower motor was bad again. turned it off and realized its actually a squeaking from my tranny. it only happens when im giving it gas. the driveshaft and guibo are not even a year old. ive never heard this noise before. its just like rubber squeaking at total random times during acceleration. any help is greatly appreciated and i plan on asking the place next to my work to look at it asap. just hope something worse doesnt happen until they can look at it. thanks again

[richardkeith97]

also car runs and drives fine. no vibration or anything.

[997_rich]

manual or auto? happens in neutral or when in gear? clutch in or out?

[richardkeith97]

its a manual. only happens when clutch is out and im giving it gas

[richardkeith97]

its getting louder and louder and the squeaking noises are getting closer together. this morning it was hardly noticeable

[richardkeith97]

if i take it easy its not as bad. bolts possibly loosened up? did guibo and driveshaft about a year ago

[jim325]

I would check the guibo. I replaced mine a few months ago(like 6) with an aftermarket one. The bolts started pulling thought the guibo. But mine made lots of noise and vibration. I put some new bolts and washers on to quiet and calm it down till my revshift guibo and center bearing show up.

I might even get some ujoints and replace those aswell.

If you bought a guibo from autozone or something like that I suggest getting a better quality one. I would atleast climb under the car with a flashlight and take a look at the guibo.

[richardkeith97]

all parts were from blunt ans driveshaft and support bearing were from portland driveline. all quality stuff

[997_rich]

Clutch area? Throwout bearing? trans input shaft flexing and wearing on guide tube?

[richardkeith97]

getting looked at today at a bmw/mini place
will keep updated. im very curious what this new noise could be.

[richardkeith97]

center support bearing is junk. whatever portland driveline uses for parts are junk. the rubber around the edge is completely missing. i installed it in july