This clutch disc is only about 9 months old. It was replaced when my TOB went out earlier this year. Upon re-installation somehow my input shaft seal was damaged and started leaking a little fluid. After a while this caused the clutch to slip. I never really drove it hard after it started as I was planning on a swap which I have since started (M50NV+G240). I'm going to reuse my M42 flywheel, pressure plate and hopefully this clutch. I cleaned it off with brake clean and a light wire brush. It looks fine to me but I am not by any means knowledgeable about clutches.
Second question. Again, I know very little about clutches. Can I replace just the clutch disc and use my OE pressure plate as long as I use an OE clutch?
Thanks,
Nick
Second question. Again, I know very little about clutches. Can I replace just the clutch disc and use my OE pressure plate as long as I use an OE clutch?
Thanks,
Nick
Comment