CSB help

[mathillois]

do i need a press to remove the center support bearing from the driveshaft? or should i be able to squeeze it out?

[mathillois]

please excuse my poor whiteout skills

[jlevie]

The splined shaft is part of the front section of the drive shaft and slides into the rear section. Make sure that the paint marks for alignment is present before separating the drive shaft halves.

[mathillois]

The splined shaft is part of the front section of the drive shaft and slides into the rear section. Make sure that the paint marks for alignment is present before separating the drive shaft halves.

what about the clamp pelican parts says you have too loosen? because i didnt do that and i just removed the center shaft off, no problem

[jlevie]

The clamping collar may not have been tight or the internal fiber bushing may be bad or missing.

[mathillois]

do i need a press to separate the center support bearing from the center driveshaft?