Clutch Rebuild

[ACHTUNG]

I've dropped my tranny and found that my throw out bearing is toast. My clutch is pretty worn as well. Since I have it all opened up I decided to replace as much as possible. This is what I have on order. Let me know if I'm missing anything:

Pressure Plate
Pressure Plate Bolts
Clutch Disk
Flywheel Bolts
Throwout Bearing
Pilot Bearing
Crank Seal
Release Bearing Guide Tube
Input Shaft Seal
Release Bearing Fork
Retainer Spring
Ball Pin

[TheRedHorseman]

a 3 foot extension to get to the GD MFing BOLTS!

(I'm going through this as we speak)

I'm doing a guibo(I'm in there already, may as well), redline MTL fluid for the tranny(check which one you have as not all use gl-4 oil), and if you're not sure of your tranny mounts you might as well take a quick look or just buy some new ones as another "while I'm in there" thing.

[ACHTUNG]

a 3 foot extension to get to the GD MFing BOLTS!

(I'm going through this as we speak)

I'm doing a guibo(I'm in there already, may as well), redline MTL fluid for the tranny(check which one you have as not all use gl-4 oil), and if you're not sure of your tranny mounts you might as well take a quick look or just buy some new ones as another "while I'm in there" thing.

Thanks!