Center Support Bearing problems

[TerribleONE]

so i finally got around to replacing my horrible center support bearing, and i put in the new one, put everything back together and there is still a similiar vibration and obvious movement in the drive line. some one help.. :roll:

[TerribleONE]

also i have a stock driveshaft from my 89' 325i, and i was wondering if the 325i driveshaft would fit in the 91' 318iS?
-thanks

[DaN]

Check the centering bushing at the tip of the driveshaft at the guibo, and the flex disc for cracks.
Are the white dots on the d/s sections lined up?
how are trans mounts?

[MR 325]

also i have a stock driveshaft from my 89' 325i, and i was wondering if the 325i driveshaft would fit in the 91' 318iS?
-thanks

No, it will not.

[jlevie]

When a center bearing fails the cause is almost always binding drive shaft u-joints. A new bearing may work for a while but the bad drive shaft will cause early failure of the center bearing. The only fix is a new or rebuilt drive shaft.

[TerribleONE]

i figured out that the problem is the worn to shit guibo, but thanks guys!