Rear output flange seal

[Schniddy]

So I need to replace this soon (doing over 1k in work in the upcoming months) due to it leaking like a total bitch.

I havn't looked at the bently yet and I only looked at a few threads.

Could somone post a quick summary of the things that needs to be done to get the seal replaced?

I know I need to pick up a 32mm thin wall socket. Everyone says you need to "make" one, but I found a website that sells it for $20.. http://www.vancouverbolt.com/store/THINWALL.HTML

Also looks like I should use Curil Sealant on the seal when I put the new one on. It was mentioned in a thread and it looks like good shit.

Other than those things that I need to buy (seal, socket, sealent) What things need to be done.

Just a quick summary will do. I'm on a break between classes and figured I'd find out. ;)

thanks
Jon

[drift]

I'm sure whn i did mine, i used 30mm ( not 32mm).