My daughter's 89 325i was shifting fine when the csb went out and caused vibration. I had to drop the rear tranny mount to facilitate removing the driveshaft. After reassembly, the tranny wont shift into 2nd for a block or so but once it does it shifts normally. WTF? Coinsidence or did I f something up like the linkage when I dropped it?
-
"Life is hard...it's a lot harder if you're stupid."
Tom
72 2002
87 327i
88 525i
88 535i
03 530i -
Not a lot of help here, it comes down to the kickdown cable but from the top at the throttle it seems to work properly. Smooth, no binding proper play. Disconnected the cable and it shifts fine. Is there something I can do to fix it?"Life is hard...it's a lot harder if you're stupid."
Tom
72 2002
87 327i
88 525i
88 535i
03 530i -
when you loosened the tranny, it must have jarred or kinked that detent cable. Remove, inspect and clean, I guessOriginally posted by h82crash View Post1989 cirrisblau-metallic 325iComment
-
I followed the cable all the way between the throttle and the tranny and it seems fine. When I pull it at about 90% of the travel it clicks at the tranny, as I imagine it should.
I guess I'll just leave it off."Life is hard...it's a lot harder if you're stupid."
Tom
72 2002
87 327i
88 525i
88 535i
03 530iComment
Comment