Hey, I recently replaced my master cylinder and my clutch was working fine for a while until I lost pressure again. I was in a hurry so I used my master bleeder cause I figured I didn't need to get under the car and open the bleeder screw on the slave cylinder again. it worked but when I parked I noticed that there was alot of brake fluid leaking from the area where the slave connects to the transmission. I lost pressure again and this time I bleed the clutch correctly, (jacked it, opened the bleeder valve..blah blah). Same thing happened again and my slave was still leaking alot of fluid. Do I need to replace the slave or is it acting that way because I didn't bench bleed the master before install. Either way I just wanna fix it because both times this happened after a long night out around 3am. I do not want that experience again.
Comment