MMP M62B44 Build Project "Jack-N-Coke"

[MonkeyMadness]

Soo the dash is is all back together finally..
Just waiting on my damn euro clock from "Fusion"
I think i got screwed, the guy has fallen off the map. Looks like I'm out $60...
So if you got a euro clock for sale. Let me know....

Now some pic's

[naika]

Nice project. I'll keep checking over here, i'm always looking for ideas to improve my set up ;)
Where are you planning on locating the oil filtre housing? I am installing an oil cooler on mine and therefore am considering replacing the oil filter housing since i need to make ful custom oil lines.
Thanks

[MonkeyMadness]

Well fixed the cam sensor issue. Resealed the motor and now ready to button up the build.
Its now more about the little things.
One thing i am holding off on is the harness.
Still have a few bugs to work out with it.

[filthiest e30]

Great progress, the engine bay looks great! Regarding the harness I saw that you commented on Andrew325is plug and play harness thread, did you end up buying one from him?

[MonkeyMadness]

Great progress, the engine bay looks great! Regarding the harness I saw that you commented on Andrew325is plug and play harness thread, did you end up buying one from him?

Thank you.
No i did not. I haven't found what i was looking for by way of the harness. So I'm working on my own. I built one that fits my need was really ,excited till i read another thread here in the v8 section mentioning pin #6 the hot wire for the o2's a wire i forgot. I got frustrated and have not revisited the harness sense. I've been procrastinating the repair cause it was a lot of work to screw up, and as i have said i'm not an elc guy...ugh
But my radio works so thats a good sign...:D

[alco]

What is the pin 6 issue?

[MonkeyMadness]

What is the pin 6 issue?

http://www.r3vlimited.com/board/showthread.php?t=298672

I'm not going to pull the hole harness apart for one wire so I'm just going to find a (key) hot 12v that's already on the harness on the motor side... ugh
I so feel like I'm drowning when it comes to this crap it's my automotive weakness...

[dirty30]

You should not have to supply a switched 12v for the 02 sensor heater. That relay should be getting a constant 12v from a large red wire and a switched 12v from a smaller red wire with a white tracer. The main relay supplies the fuel pump and 02 sensor their switched 12v.

[MonkeyMadness]

You should not have to supply a switched 12v for the 02 sensor heater. That relay should be getting a constant 12v from a large red wire and a switched 12v from a smaller red wire with a white tracer. The main relay supplies the fuel pump and 02 sensor their switched 12v.

Ok so pin #6 is not needed as long as I can pull from red wire supply.
So i should disregard all that's posted on the link above?

[naika]

I did not plug the Pin 6 from the V8 harness on mine (black/blue wire), and it runs just fine ;)

[MonkeyMadness]

I did not plug the Pin 6 from the V8 harness on mine (black/blue wire), and it runs just fine ;)

Well it would be pin#22 on the x20 v8 harness to pin# 6 on the c101.

[MonkeyMadness]

Hey you guys know what day it is?

[Zacm829]

Any updates? I'm just in the infant stages of the same swap!

[Vtec?lol]

Dem asses

[MattAvino]

moaaar