Big Block or Small block swap?

[ak-]

Swap in a Ken Block

[artoo93]

Go big or go home!! Just my .02 worth!! I could see a built 350 going into a e30 though!! Can make a lot of horses with relatively low cost as there are a lot of bolt on options for a Chevy 350!! Mine in my Camaro had 425 hp with off the shelf parts and I was a poor high school grad/college student when I did that one!

[JasonC]

There was a 383 stroker with 4 speed on here not to long ago. But haven't seen any BBC yet. I do believe that there is one in FL that has a Big block Old's. But it may have a tube front end under it.

[Farbin Kaiber]

In before a MERLIN or GMPP 572 e30 thread exists.


(I don't care until it's a NRE30.)

[Bglad]

A BB would fit, but it is wayyyyyy too heavy for an e30. A Iron SB is too heavy IMO too.

[tokoloshe]

Ive seen a carbureted 350 and auto trans swap on the net 10yrs ago think it was a maroon car somewhere down south, not much of a write up though. Don't think its possible to get a big block in the bay and make it practical. Big block would just be to heavy for the front end and simply not fit

[AlexHale]

Has anyone ever swapped a big or small block Chevy into an e30? I know ls is similar, but an older 350 or so? If so, link to thread