M60/62 Turbo kit....in the works

[george graves]

Sub'ed!

[dougie30]

This is going to be so awesome.... Can't wait to see the finished product!

[driftingminor913]

Okay back at it!

[driftingminor913]

So I finally got a turbo that's worth putting on here will be finishing the manifold this weekend before I go out of town....or atleast I hope so

[driftingminor913]

It's all the same material maybe just a different finish. An the next one I make I will experiment with a tight radius 90

[CorvallisBMW]

sub'd

[LJ851]

The manifold and pipe look good but the transition between them looks really abrupt and doesn't seem to match. Why not use curved pipe there? Even if you had to pie cut it to tighten the radius.

[Old city bimmer]

Look interesting ...sub'd

[LoneWolf]

Cool, thanks, and sweet build.

[driftingminor913]

No nothing really, just didn't think of it at the time

[LoneWolf]

That's what I had on hand but when I make them again I will be sure to combine them so it's one big flange

I've started drawing one up in CAD as a single flange. Was just curious if there was something that pushed you away from a single flange.

[driftingminor913]

That's what I had on hand but when I make them again I will be sure to combine them so it's one big flange

[LoneWolf]

Any reason you went with the individual flanges instead of making one large one per side?

[Denny]

I built the whole harness from scratch with the c101 and relays..... I can provide full bolt on wiring and ms2 v3.57 using stock COPS, idle valve,vr sensor...etc and startup map tune

[driftingminor913]

I will for sure keep you in mind, I hate wiring and going Ms3 and making a adapter harness since I don't wanna make a whole new one