Hey guys, im planning a m60 swap in the next year, i always go though wiring first and i printed some thing off.
I have a early square plug car so i transferred all the pins to the correct ones.
I found that pin 24 and 20 need to be routed to the C104 plug in the glove box, which is fine with my, one being the Tach and one being Fuel Consumption, but the c104 is a 3 wire plug, and the third wire you need for the car to run(at-least when it comes to m20/m10)
do i need this wire plugged in for this swap? and if so where do i pull it from?
thanks
I have a early square plug car so i transferred all the pins to the correct ones.
I found that pin 24 and 20 need to be routed to the C104 plug in the glove box, which is fine with my, one being the Tach and one being Fuel Consumption, but the c104 is a 3 wire plug, and the third wire you need for the car to run(at-least when it comes to m20/m10)
do i need this wire plugged in for this swap? and if so where do i pull it from?
thanks
Comment