Hey y'all!
Bought an S62 and I've begun tearing the engine down and reading through some technical litterature. The service manual describes a procedure and tool kit for syncing the throttle bodies after reassembly. Basically the kit consists of two dial indicators, a mount, and two shims used for adjustments.
Shown here: http://workshop-manuals.com/bmw/5_se...62)/page_1362/
I have dial indicators and I'm sure I can rig up a mount that will work good enough to mimic the BMW mount. The problem is that I don't know the dimensions of the shims. Is there anyone out there with access to one of these kits who can snap a few pics with some measurements for me? I'd also be down to rent it from someone, I know how expensive this set is and wouldn't blame anyone for trying to recoup some of their hard earned cash.
Bought an S62 and I've begun tearing the engine down and reading through some technical litterature. The service manual describes a procedure and tool kit for syncing the throttle bodies after reassembly. Basically the kit consists of two dial indicators, a mount, and two shims used for adjustments.
Shown here: http://workshop-manuals.com/bmw/5_se...62)/page_1362/
I have dial indicators and I'm sure I can rig up a mount that will work good enough to mimic the BMW mount. The problem is that I don't know the dimensions of the shims. Is there anyone out there with access to one of these kits who can snap a few pics with some measurements for me? I'd also be down to rent it from someone, I know how expensive this set is and wouldn't blame anyone for trying to recoup some of their hard earned cash.
Comment