Announcement

Collapse
No announcement yet.

removing console around HVAC and stereo

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    removing console around HVAC and stereo

    how do i remove the center plastic console that surrounds the HVAC controls and stereo? i need to replace my headunit. wiring and installation isnt a problem, just how to get the plastic console out.

    thanks,
    Bokes
    173rd ABN

    #2
    shouldnt need to do that to replace stereo...

    pop out all the little plastic covers where the hazard/defrost switches are. There will be some phillips screws up at an angle there to remove.
    Then there are some tiny 8mm nuts going up vertically from the storage tray area on the left and right.

    Pull off the hvac control knobs
    OBC might hold it in still... but i cant recall removal of that off-hand
    Below the radar...

    Comment


      #3
      Originally posted by UNHCLL
      shouldnt need to do that to replace stereo...

      pop out all the little plastic covers where the hazard/defrost switches are. There will be some phillips screws up at an angle there to remove.
      Then there are some tiny 8mm nuts going up vertically from the storage tray area on the left and right.

      Pull off the hvac control knobs
      OBC might hold it in still... but i cant recall removal of that off-hand
      thanks. i can figure it out from there. :)
      173rd ABN

      Comment


        #4
        The OBC is held in by 4 screws on the back of it. It will pull out with the panel and you can just unplug it.


        Nick

        Comment

        Working...
        X