About swappping to....

[92 mtechnic cabrio]

holy necropost

[Kerrath]

For a second I thought he had a tach as big as the steering wheel. That'd complete his car.

[Money$hit]

I would sincerely fly to the edge of the earth to punch someone in the face who swaps a rotory motor into a bmw. Any non mazda car for that matter.

[Adrian_Visser]

aghhhhh a honda engine in a bmw? that guy should go to jail

[Slangbox]

Or if you really want no torque, swap in an F20C like these guys did: http://www.youtube.com/watch?v=ICsrADnWFKU

No torque, but 240 hp at 8300 RPM is pretty damn good for an N/A four-pot.

[gazellebeigem3]

Whatever i run, its not going to have that junk ass fuel injection.

[MazterDizazter]

1JZGTE > 7MGTE

13B N/A? So you want the same horsepower and less torque than you started with? How about a 13B Turbo.

Or if you really want no torque, swap in an F20C like these guys did: http://www.youtube.com/watch?v=ICsrADnWFKU

[Money$hit]

and booosh.

[Money$hit]

linelock for sure. im thinking a 350 fast burn with a 350 turbo. thoughts?

idk pick up a scoggin dickey catalogue and pick out a sick crate motor. Ill bring the polished edelbrock manifold.

[gazellebeigem3]

9 inch ford rear ftw. 3.73 posi. linelock.

/thread

linelock for sure. im thinking a 350 fast burn with a 350 turbo. thoughts?

[DRTSRFR]

This guy did it...

http://sacramento.craigslist.org/cto/1027558334.html

[Money$hit]

9 inch ford rear ftw. 3.73 posi. linelock.

/thread

[gazellebeigem3]

yesh, i was thinking that i could convert it to rwd as well.

Does anyone have a diy for this swap?

[Money$hit]

u puttin one in the camry? that would be dope.

[gazellebeigem3]

do you guys know of any 305s for sale?