E30 clusters aren't THAT bad right? :)
-
Mtech1 v8 build thread - https://www.r3vlimited.com/board/sho...d.php?t=413205
OEM v8 manual chip or dme - https://www.r3vlimited.com/board/sho....php?p=4938827 -
Nope, I've actually gotten quite good at pulling/reinstalling the thing.
Matt, was your tach doing the same thing?Last edited by Jand3rson; 03-17-2010, 08:36 PM.Comment
-
It was originally completely dead, then it would start jumping from 0 to 2000rpm when the engine reached that point and "skip" up the scale, then fall back to zero. I replaced the 6k tach with a 7k unit that was originally out of the '87 cluster I was using, and no problems now. I'm planning on doing the 885 head swap along with a bottom end rebuild in the next month or two, so I went ahead and threw the 7k unit in.
"See, we're adding a little something to this month's sales contest. As you all know, first prize is a Cadillac Eldorado. Anyone wanna see second prize? Second prize is a set of steak knives. Third prize is you're fired."Comment
-
Yeah, mine will jump up to 2k when I start the car, and unless I wind it up to (what I suspect is) about 3k, it falls down to 0, then goes back up to 2k. Then it will start working normally, and work fine until the next time I drive the car. But I have a new one on the way, so that should take care of it.Comment
-
you know the needles come off, right?
anyway, if you have a 13 button OBC you can hit the 1000 and 1 buttons together and it will tell you the amount of fuel in liters.
Originally posted by ROLLingKINGOriginally posted by slammin.e28Comment
-
So Matt, you were absolutely right! Swapped in the new fuel gauge and it works perfectly, as does the tacho.Comment
Comment