Announcement

Collapse
No announcement yet.

rear end vibration.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    rear end vibration.

    When i hit 20 miles an hour the rear end vibrates hard then like @ 23 mph it goes away. It does it everytime on accel. Is this normal?

    ( erik keep quiet but the swap is done )

    #2
    No,
    My car was doing the samething, I checked all the mounting points and found the tranny mounts had come lose.

    Tighten then and all is good.
    If all the mounts are tight, check the axle shafts for free movement in and out and your wheel bearings.

    Also a worn guibo and center support bearing can cause the same feeling. If you have done a drive shaft change make sure the preload on the center support was done correctly.

    Tony

    Comment


      #3
      how do i make sure of the preload?

      Comment


        #4
        make sure you have all the bolts in the guibo
        Your signature picture has been removed since it contained the Photobucket "upgrade your account" image.

        Originally posted by TimKninja
        Im more afraid of this thread turning into one of those classic R3v moments, where Pizza gets delivered.

        Comment


          #5
          If you have the bently manual it explains the procedure. I don't remeber it off hand, I can look tonight and let you know tomorrow.

          Or if some one here has one handy they can tell you.

          Comment


            #6
            all the bolts are there i just finshed the 5 spd swap. Thanks for everything ill look in the bentley.

            Comment

            Working...
            X