If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
What is the correct way to do this? I used the search function and checked around google. didnt find much that gave me direct intructions. Anyone do a write up that I havent found?
Need to know this too. All I have is it rigged through the license plate holes and through the plate..... Oh, and what a good idea those were, we all know everyone loves the rust that accumulates back there.
Yeah thats what I dont want to happen. I know in my filler there is two holes for screws that go next to the license plate lights and then I have these 2 caps that go in the oblonged holes that have studs for screws. I need to drill a hole for the stud and then get a screw that fits to the stud can expand in the metal and hold it in place. Honestly, i dont want to hack up my car, so Im pretty sure there is an easier way. If thats how everyone else has been doing it, then I might just take that route.
Comment