Announcement

Collapse
No announcement yet.

Temperature Gauge Flippin' Out

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Temperature Gauge Flippin' Out

    I recently changed my timing belt and other belts, water pump, thermostat, fuel filter, FPR and when i start the car the temp gauge starts tripping out. I noticed though when I press the gas it goes up to where it supposed to be and stays still but when I let go of the gas it starts fluctuating between where it is supposed to be and the lowest position. Any suggestions of what it might be? Thank you all for your help, Jai
    -1975 BMW 2002
    -1989 BMW 325is

    #2
    the connection to the temp sender

    Comment


      #3
      make sure ground nut no back is tight
      Continuous For Sale Thread
      323i s50

      Comment


        #4
        Does it go up and down when you roll up the windows and turn headlights on?
        If so mostly likely its a Bad ground on motor side. I think its located on and oil pan bolt... Maybe dirty, clean up and should be ok or replace and mount somewhere else.

        My cousin had this problem and that fixed it.

        325i LSDed, 17x8.5 et15 BBS CH's, Bilstein Group N Suspension

        Comment


          #5
          Thanks

          I'll check all of my grounds and report back. Thanks again
          -1975 BMW 2002
          -1989 BMW 325is

          Comment


            #6
            this is a common problem... you'll ahve to take out the cluster and partially take it apart to get to the nut on the back of the temp gauge

            Comment


              #7
              corrected

              Hey thanks for the pointers...
              For some reason it corrected itself, but now the mileage does not work=). If it's not one thing it's the other. GRrrrr....welcome to E30 world huh=)
              -1975 BMW 2002
              -1989 BMW 325is

              Comment

              Working...
              X