Both of my motor mounts failed at the same time. So now I'm putting in new ones. The driver side comes down dead on, but I can't get the passenger side mount to properly line up with the correct hole, it seems to be pretty far off. I've lowered and raised this thing for a while now, is there any trick to this or do i just need to fight with this more?
-
1987 325is - sold
2001 330i - New DD -
Pretty much you just have to fight with it. When Josh, Jordan and I swapped out Josh's motor, one of us had to stand on the engine to get it lined up correctly. lol -
thx1987 325is - sold
2001 330i - New DDComment
-
Try unbolting the arm from the side of the engine block a bit.Adam Fogg- '88 M3
Common sense- It's the new 'gifted'Comment
-
and unboolt the tranny mounts
Comment
-
got it, it took a big hammer and me knocking the hell out of my jack1987 325is - sold
2001 330i - New DDComment
-
Chain Come Along.
Used it a few times now to line up the driveline.
Works pretty damn good.Comment
Comment