If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Has anyone done this without taking it all apart first? I have a few spares and wondered if anyone had got it done? the temp in the oven is about 400 degrees and wondered if the seals would hold up to that?
The seals will not survive that. You would have to fully disassemble the pump, powder coat the exterior pieces, and reassemble the pump with new seals.
The car makes it possible, but the driver makes it happen.
Jim Levie, Huntsville, AL
Comment