The Windy City BMW CCA VintageFest event is this Sat and I've slowly gotten my car back together after a total respray, but I'm left with installing the "is" skirts now to finish it off before the show. Problem is, I can't quite figure out where the all the hardware goes. As others have recommended, I'm gonna use 3M adhesive tape so I don't have to drill holes or use the top clips. I've figured out the bottom clips that clip over the pinch weld and that the two phillips screws replace the lower fender mounting screws and that the four black expanding rivets go into the holes in the rear of the skirt and into holes I'll need to drill in the rear wheelwell, but not sure about the rest. Can someone school me on where the other hardware pieces in the photo go? Also, what mounts into the slot on the top of front skirt piece shown?
http://www.flickr.com/photos/5924381...7627731135334/
http://www.flickr.com/photos/5924381...7627731135334/
Comment