no heater!

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • timninja
    Grease Monkey
    • Feb 2011
    • 302

    #1

    no heater!

    I can't use the search feature on my phone and my google results aren't helping me at all, so my heater doesn't work period,I can't find the fuse locations,and I want to find thoose before I replace the damn blower motor,any help would be greatly appreciated.
    Thanks for your time,
    -Tim
  • bmw325csi
    R3V Elite
    • May 2007
    • 4045

    #2
    Fuse is under the hood on the driver side near the firewall. Not sure on the number at the moment, but I would get a test light and check them all, replace as needed.


    If its not your fuse, you can check the resister on the blower motor. It slides under the motor.
    harry/harout

    Comment

    • devon.818
      Banned
      • Feb 2011
      • 2937

      #3
      better hope its not the blower motor. does it blow anything on any settings?

      people say the blower motor is easy, it is....after you your first one. so it will suck.

      plan for an hour-two

      Comment

      • bmw325csi
        R3V Elite
        • May 2007
        • 4045

        #4
        Blower motor took me 15 minutes without even removing my strut bar.
        harry/harout

        Comment

        • smooth
          E30 Mastermind
          • Apr 2005
          • 1940

          #5
          mine blows hot air but makes a horrible racket so I don't go above 1.
          can I do anything about that or do I have to replace the whole unit?
          Das ist nicht nur nicht richtig, es ist nicht einmal falsch!

          Comment

          • bmw325csi
            R3V Elite
            • May 2007
            • 4045

            #6
            replace the whole unit, I doubt they sell just the cage
            harry/harout

            Comment

            • timninja
              Grease Monkey
              • Feb 2011
              • 302

              #7
              Oh OK,so the engine bay fuse box has a blower motor fuse?I saw on a different forum I found threw Google and it said fuse 75 or 76 in the glove box but all I find is the ecu.
              my heater does not work at all on any setting.
              If I want to replace the blower motor who is a reliable source to buy a new one from?

              Comment

              • timninja
                Grease Monkey
                • Feb 2011
                • 302

                #8
                OK,so I found fuse #20-a/c and heater motor fuse 30amp blown,so I replaced it,turned on my heater to hot then to level four and the fuse blew again and my cars power went out then came back on.
                So where do I go from here?

                Comment

                • jlevie
                  R3V OG
                  • Nov 2006
                  • 13530

                  #9
                  Check for shorts in the wiring (hint, disconnect the blower & resistor and see if a smaller fuse blows) first. If that fuse doesn't blow, replace the resistor if shorted or the blower.
                  The car makes it possible, but the driver makes it happen.
                  Jim Levie, Huntsville, AL

                  Comment

                  • timninja
                    Grease Monkey
                    • Feb 2011
                    • 302

                    #10
                    OK,sweet,I haven't removed the blower access panel,what nuts hold it in?the plastic butterfly nuts or the smaller hex heads?I'm not with my car is why Im asking.

                    Comment

                    • Zinno_e30
                      E30 Addict
                      • Jul 2010
                      • 553

                      #11
                      Use this as a reference: http://www.r3vlimited.com/board/showthread.php?t=60297

                      I would replace any of the fuses related to the heat/cooling system: 3, 18, 19, 20
                      However, Fuse 20 is the one that you should replace for sure.

                      I recently replaced all of my fuses and I was able to get rid of some electrical gremlins in the process. Hope this helps.

                      Comment

                      • timninja
                        Grease Monkey
                        • Feb 2011
                        • 302

                        #12
                        OK ill let you know what happeneds when I do.

                        Comment

                        Working...