Starting problem, Fusible relay?

[GrimmSpeed]

Hey guys,

I have an 89is motor swapped into an 85e. I adjusted the valves last weekened and replaced the IM gasket. I got the car started and it ran about 2 blocks before stalling. Got the car started again but it died after a few seconds. I've checked spark and fuel and both seem good. The car wont start at all now but cranks good. I was able to get it started breifly by spraying starting fluid into the intake, it dies shortly after. Does it sound like the fusible relay is the issue or something else?

Thanks!

Mike

[jlevie]

That doesn't sound like a fusible link problem. The first things I would do would be to run a smoke test and Check the rail fuel pressure.

[GrimmSpeed]

No manifold leaks, 45ish psi at the rail, new regulator, new plugs. Any more ideas? testing the cps tonight.

Mike

[GrimmSpeed]

CPS tested find at 540 ohms. I will be borrowing and ecu from Blunttech this week!

Mike