Announcement

Collapse
No announcement yet.

heater doesnt work!

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #16
    On the resistor that's in the blower housing is a single set of points. I wish I had a set out to take a pic of, but I don't. If your testing leads you to the blower motor, the resistor is behind the blower motor itself.

    I had to look it up in my Bentley manual, it's been awhile since I messed with a blower problem. It's in section 15 page 45 in my manual.

    Comment


      #17
      haha makes me wish i had a manuel for it right now. i have never needed one before. i have a pretty good knoledge of the car. thanks man. will be doing testing this weekend.

      Comment


        #18
        If you haven't tackled this yet, I took some pics today as I removed the blower motor from the car I'm parting. Let my know and I'll post them up in the thread.

        Comment


          #19
          yeah dude please post them up. im trying to figure out what is all in the blower circut. but now i have a bigger issue. now none of my turnsignals work :(

          Comment


            #20
            OK. I finally got back to this thread. In the last pic you'll see the set of points I'm referring to, under the coils. I take some 400grit wet or dry, fold it over grit side out, and pull it thru a couple times, then check with an Ohm meter to see if you did any good.
            Last edited by Quadrajet; 01-03-2014, 12:25 AM.

            Comment

            Working...
            X