Oil level sender resistance measurement?

[Garageaholic]

Can someone please measure the resistance of the oil level dynamic pins 1 and 2 from the sensor itself? I am not using this sensor anymore for my s62 and want to simulate a"full" as to remove the active check control light.

The static is easy, just ground the wire. The dynamic is harder because it needs some sort of resistance to ground.

Thanks so much guys for the help.

[Swanny]

I'm stripping down my b25 block today so I can send you some measurements.

[Garageaholic]

Thanks Sean!!

[SpecM]

info stolen from e30tech:

Ground pin 2 in C101
Ground pin 10 in C101 through a 1000 Ohm resistor.

[Garageaholic]

Hmm 1K...I'll try that tonight. Thanks!

[Swanny]

It has this many...

[Garageaholic]

Perfect. You're both telling the same story. Thanks guys.