Just picked up an e30. Need some questions answered.

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • kwseattle
    replied
    Originally posted by jalopi
    Holy shit... did the shop you took it to find the bolt? Small miracle it didn't self paperweight a while ago.
    Yep, the bolt was just hanging out in the timing cover. You should see the belt they pulled out, I'm surprised it didn't snap before I had them look at it.

    Sent from my Nexus 5

    Leave a comment:


  • jalopi
    replied
    Holy shit... did the shop you took it to find the bolt? Small miracle it didn't self paperweight a while ago.

    Leave a comment:


  • kwseattle
    replied
    Originally posted by Keith M
    $1100 for a timing belt change??
    This included diagnostic time for a bunch of other stuff as well. I'd rather that than a new engine.

    Sent from my Nexus 5

    Leave a comment:


  • Keith M
    replied
    $1100 for a timing belt change??

    Leave a comment:


  • ELVA164
    replied
    Wow, it's a small miracle you didn't lose your valve train.

    Leave a comment:


  • kwseattle
    replied
    Holy s***. Got my problems figured out. Can't believe what it was: the timing belt tensioner was missing the retention bolt. The timing belt was literally flapping around and creating my rough idle problems. A third of the timing belt was missing. Teeth were intact but the width of it wasn't.

    Couldn't have been a better idea to take it in, even if it did run me close to $1100. Would've lost an engine pretty quick if I hadn't.

    Sent from my Nexus 5

    Leave a comment:


  • kwseattle
    replied
    Originally posted by RagtopE30
    Does the light that is constantly flashing have the word "Check" on it and located in the center of the cluster?
    No, it's the actual check engine light. After performing a stomp test it will blink, blink again, and then instead of flashing the usual 1XXX Motronic fault code, it just flashes constantly.

    Sent from my Nexus 5

    Leave a comment:


  • RagtopE30
    replied
    Does the light that is constantly flashing have the word "Check" on it and located in the center of the cluster?

    Leave a comment:


  • kwseattle
    replied
    Originally posted by bmwstudent
    They are designed to be non-servicable but I'm sure someone somewhere has figured out how to source a proper size joint to fit it. However, I have just been sourcing good used ones.
    I'll look around. Car is finally in the shop for engine troubles and I asked them to look at the steering as well.

    I had trouble diagnosing the problem with my engine because the stomp test didn't return any useful info, just a constant flashing. A poor idle, misfiring, and trouble starting could have so many contributing factors.

    Sent from my Nexus 5

    Leave a comment:


  • bmwstudent
    replied
    They are designed to be non-servicable but I'm sure someone somewhere has figured out how to source a proper size joint to fit it. However, I have just been sourcing good used ones.

    Leave a comment:


  • kwseattle
    replied
    Originally posted by bmwstudent
    You mentioned a rough spot while turning the wheel. I hate to tell you this but the past three e30's I've rehabbed have need steering column u-joints. Check them before you find out in a turn that they've decided to lock up on you. Not the easiest job but definitely one you want to do. E30's drive terrible after the've been run into a tree or of the road.
    About the U joint, can they be refurbished? I actually have a Z3 rack in the mail and I'll have to do the modification to it allow it to fit.

    Sent from my Nexus 5
    Last edited by kwseattle; 12-30-2013, 03:37 PM.

    Leave a comment:


  • kwseattle
    replied
    So the tach and radio power was a fuse. I wouldn't be surprised if the alternator was in fact on its way out however.

    It has been idling really rough and having trouble starting, it's also stalled a couple times when idling.

    Weird thing is, the stomp test gives me a constant flashing, no codes, but the CEL is on.

    Sent from my Nexus 5
    Last edited by kwseattle; 12-30-2013, 01:32 PM.

    Leave a comment:


  • mkcman17
    replied
    Quite often, and I have put together many a-cluster.

    Leave a comment:


  • dnguyen1963
    replied
    Originally posted by mkcman17
    Why does everyone seem to think the si board is always the problem?

    Change the timing belt, oil, spark plugs and vac lines. m20s don't need much to keep going.
    After about 7600 posts, how many times have you seen people asking about the SI board? The Si board is a very good indicator of something wrong with the system. It can often point you to the right direction.

    Leave a comment:


  • mkcman17
    replied
    Why does everyone seem to think the si board is always the problem?

    Change the timing belt, oil, spark plugs and vac lines. m20s don't need much to keep going.

    Leave a comment:

Working...