Headlight help

[Thizzelle]

take grille off and undo the 3 screws holding light in. wala

[15Michaeljoseph]

for the fog light you could either check the fuse or replace that bulb too.


--sent from my igloo via carrier penguin

[rcsoundn1]

i have a great set of sealed beams for sale, ready to ship! shameless plug...... Glad you got it worked out!

[Dakotademon7]

I would do a voltage test on the headlight plug. I base this on the fact that it was posted that the low beam AND fog light doesn't work on one side.

[Lake]

nvm i always make everything harder then it needs to be. thanks for the help guys!

[Lake]

this is the head light

[Lake]

awesome guys thanks but how do i replace it if it's all glass? it's not like i can just turn it right and pull it out.

[NoM54me]

You have a burned-out headlight, homie. Better undo any screwing with the wiring you did. The outer lamps contain a filament for each the low beam and the high...two filaments. The low beam filament burned out. Replace the bulb.

[dsphil]

your low beam is burnt. replace with a new one and problem will go away. only $10

[Dakotademon7]

Did you check fuse 13 ?

[Lake]

If you have sealed beam lights, they are dual filament and the low beam could be burned out. Swap the bulbs and see if the problem follows the bulb.

it's all one glass piece off an 85 325

i took the light and plugged it into the passenger and it doesn't turn on. but it turns on with the high beams on.

[AndrewBird]

If you have sealed beam lights, they are dual filament and the low beam could be burned out. Swap the bulbs and see if the problem follows the bulb.

[Lake]

Hello R3v!

So im stumped. when i turn my low beams on only my passenger light and fog lights come on and my driver sides stay off, when i turn my high beams on all 4 lights come on. i tried wiring my passenger side to my driver side low beam and nothing happens.


The fuses are good.



Yes i've checked the blinker fluid, it's at the correct level. :hitler: