Got my Ireland Engineering Front Strut Brace...have question.

[87Blue325iC]

Installation is obvious, of course. But you are supposed to drill an extra 8mm hole into the strut tower to add a bolt. No bolts came with the brace, and no instructions. What has everyone else with this brace done, and what hardware should I get? I'm going to be changing out my suspension shortly, so if I need the struts out of the car to drill the hole in the tower, that is not a problem.

Thanks,
Aaron

[Alpine-E30]

You don't need to drill a hole, just mount the bar to the bolts already on the car.

[Justin B]

As was already said, you dont have to, but it doesnt hurt either. I have basically the same brace (sparco) but didnt drill the third hole when I had the chance with all of the suspension out. It still works just fine